This self-assessment helps you determine if you should take the PacketShaper Advanced Traffic Analysis and Troubleshooting (ATAT) course without first attending the PacketShaper Specialist (PS) course. There is very little overlap between the two courses, and without the proper preparation the ATAT could be a daunting challenge.

If you answer all questions correctly, please proceed to the registration for the ATAT course.

If you answer one or two questions incorrectly, please review those subject areas carefully before attending ATAT.

If you answer three or more questions incorrectly, or if you do not feel comfortable with the questions, we recommend that you attend either the PacketShaper Specialist or the PacketShaper Bootcamp instead.

Question 1: Configuration

If you set the Site Router to IP 10.0.0.1, how does it impact PacketShaper's functionality? Choose ONE.

Answer alternatives:

	PacketShaper identifies active router in a redundant topology with the Site Router IP
	PacketShaper communicates with outside services through the Site Router's IP address
	PacketShaper monitors and shapes only frames with Site Router's MAC address
	PacketShaper excludes traffic to Site Router's IP through the sameside mechanism

Question 2: Classification

Refer to the exhibit. Which policy is applied to the class Inbound/London/FTP? Choose ONE.

Answer alternatives:

	Priority (2)
	No policy is applied
	Priority (3)
	Rate (3) 0

Question 3: Monitoring

Refer to the exhibit. The only classes showing up in the Monitor Response Time screen are Outbound. What does it mean?

Answer alternatives:

	Response Time Measurement was enabled on the outbound partition only
	All TCP flows crossing the PacketShaper originated inside
	TCP-based applications' response times are always measured on the outbound
	Policies on this PacketShaper are applied to outbound TCP classes only

Question 4: Controls

Refer to the exhibit. What will the control set on the Inbound/HTTP class accomplish? Choose ONE.

Answer alternatives:

	Guarantee 300 kbps to each HTTP flow, burstable at priority level 4
	Allocate 300 kbps in chunks to each HTTP flow starting with priority level 4
	Guarantee 300 kbps in aggregate to the Inbound/HTTP class, burstable at priority level 4
	Allocate non-burstable 300 kbps in chunks to the HTTP class starting with priority level 4

Question 5: Xpress

Refer to the exhibit. On the PacketShaper 1, under Xpress tab ' Xpress->IP settings, which IP address should be entered? Choose ONE.

Answer alternatives:

	10.0.2.10
	10.0.1.20
	10.0.2.1
	10.0.1.1

Question 6: Maintenance

Which configuration file can add features to the existing configuration without replacing it? Choose ONE.

Answer alternatives:

	settings.cfg
	config.cmd
	config.ldi
	basic.cfg

BLUE COAT ACQUISITION

Effective June 9 Blue Coat will directly only offer the following Packeteer training courses:

Packeteer Specialist
- Level I
Packeteer Advanced Traffic Analysis & Troubleshooting
(Level 2)
PacketShaper Bootcamp

Training on other products will still be available at ATC locations worldwide for the next 90 days. You can e-mail training@bluecoat.com if you need any additional information or clarification

Resource Library